Difference between revisions of "AFE-E630 COM0、COM1"

Revision as of 10:20, 17 December 2024

UART（RS232 or RS485）

Configure RS232 or RS485

Only ttyS3 and ttyS4 support RS485 mode and the default mode is RS485. Set RS232 or RS485 separately (0 means to RS232; 1 means to RS485):
Set ttyS3 to RS232 mode and ttyS4 to RS232 mode

# fw_setenv uart_mode_cpu 3:0,4:0
# reboot

Set ttyS3 to RS232 mode and ttyS4 to RS485 mode

# fw_setenv uart_mode_cpu 3:0,4:1
# reboot

Set ttyS3 to RS485 mode and ttyS4 to RS232 mode.

# fw_setenv uart_mode_cpu 3:1,4:0
# reboot

Set ttyS3 to RS485 mode and ttyS4 to RS485 mode.

# fw_setenv uart_mode_cpu 3:1,4:1
# reboot

For example, set COM0 ,“Baud rate” to 115200 ,“Data bits” to 8,“Stop bits” to 1,“Parity” to None,“Flow control” to None.

# stty -F /dev/ttyS3 115200 cs8 -parenb -cstopb -crtscts

Send and Receive Data

The following figure shows the connection mode.

COM0_GND=>COM1_GND

COM0_RS232-TX=>COM1_RS232-TX

COM0_RS485+/RS232-RX=>COM1_RS485+/RS232-RX

COM0_RS485-=>COM1_RS485-

贴一张图片

Taking COM0 as receiver and COM1 as sender(RS485) :

# #---- COM0 as receiver ----# #
# stty -F /dev/ttyS3 115200 cs8 -cstopb -parenb -crtscts
# cat /dev/ttyS3 &

# #---- COM1 as sender ----# #
# stty -F /dev/ttyS4 115200 cs8 -cstopb -parenb -crtscts
# echo pass > /dev/ttyS4

# #----If no error, the receiver will receive “pass”----# #
pass

Note:

1、Receiver should run before sender.

2、The “serial port parameters” should be the same for sender and receiver.