Difference between revisions of "1. Using AndroidTool."
Xingxing.li (talk | contribs) |
Xingxing.li (talk | contribs) |
||
| Line 8: | Line 8: | ||
'''Debug Cable''' | '''Debug Cable''' | ||
| − | + | [[File:ROM-5780 debug cable.png]] | |
'''Step2 Double click DriverInstal''' | '''Step2 Double click DriverInstal''' | ||
Revision as of 08:49, 26 May 2023
Step1 请先准备一条mirco USB 线材和Debug Cable
Mirco USB
Debug Cable
Step2 Double click DriverInstal
插一张DriverInstall图片
Step3 Enter into MASKROM mode .
There are two ways to enter MASKROM
1. Hardware way to enter MASKROM
Step1将Mirco USB的OTG端插在板卡的USB0_OTG1端口上，USB端插在PC上，如下图
插一张图片
Step 2 将底板ROM-DB5901的SW1（BOOT SEELECT）拨码如下
插一张SW1拨码开关的图片
Step 3 使用12V 3A的电源上电，并打开瑞芯微开发工具V2.65，如下图
插一张进入MASROM设备模式的图片
Step 4当板卡进入MASKROM模式后，将底板ROM-DB5901 SW1的4、5拨回OFF（1-6均为OFF），再点击“执行”开始进行烧录。
插一张ADB的图片
2. Software way to enter MASKROM
When the device boot up to android or debian, you can use ADB or Debug console, send command "reboot loader" .
Or Press "ctrl + c" key when booting into uboot, until get the following information on debug console :
Android 10：
Hit any key to stop autoboot:0
rkboot # <INTERUPT>
rkoot # =>rbrom
I2C2 speed: 100000Hz
Debian 9.x'：
Hit any key to stop autoboot:0
rkboot # <INTERUPT>
rkoot # =>rbrom
插一张loader图片
点击“高级功能”，进行选择，点击“进入Maskrom”，如下图所示：
插两张设置图片