IoTGateway/BSP/Linux/iMX6/Mfgtool

User Guide for using mfgtool

Enter recovery mode

ROM-5420

Set the correct boot mode, then power on.

ROM-3420

Set eng mode,then power on(1-off,2-on)

ROM-7421

Set eng mode,then power on(1-off,2-on)

UBC-220

Set eng mode,then power on(1-off,2-on)

Other Projects

Set eng mode,then power on(1-off,2-on)

Connect the OTG to the PC

After connecting to PC, a HID-compliant device will be shown in the Device

Modify config file

modify cfg.ini

mfgtools/cfg.ini

ROM-5420

[profiles]
chip = Linux

[platform]
board = SabreSD

[LIST]
name = ADV u-boot

[variable]
dtb = imx6dl-rom5420-b1
mmc = 0
image = fsl-image-x11-imx6qrom5420-20141218174618.rootfs.sdcard

ROM-3420

[profiles]
chip = Linux

[platform]
board = SabreSD

[LIST]
name = ADV u-boot

[variable]
dtb = imx6q-rom3420-a1
mmc = 0
image = fsl-image-qt5-imx6qrom3420a1-20170117173534.rootfs.sdcard

ROM-7421

[profiles]
chip = Linux

[platform]
board = SabreSD

[LIST]
name = ADV u-boot

[variable]
dtb = imx6qp-rom7421-a1
mmc = 0
image = fsl-image-qt5-imx6qprom7421a1-20170116192833.rootfs.sdcard

UBC-220

[profiles]
chip = Linux

[platform]
board = SabreSD

[LIST]
name = ADV u-boot

[variable]
dtb = imx6dl-ubc220-a1
mmc = 0
image = fsl-image-qt5-imx6dlubc220a1-20170208223506.rootfs.sdcard

which operation you want to do

[LIST]
name = 
ADV Image 		update whole image(including rootfs)
ADV kernel		update zImage and dtb file
ADV u-boot		update u-boot
ADV adv-loader		update adv-loader

define config variable

[variable]
dtb = (name of dtb file)
mmc = ( “0” means “emmc” ,”1” means “SD Card” .)
image = (If you want to update whole image,fill the image file name )

After updating image(ADV Image)

1. then power on system
2. perform “resize2fs /dev/mmcblk0p2”
3. restart system.

Copy file

You must copy file to Profiles\Linux\OS Firmware\files

ADV Image 		fsl-image-qt5-imx6qprom7421a1-20170116192833.rootfs.sdcard
ADV kernel		zImage and dtb file
ADV u-boot		u-boot_crc.bin.crc & u-boot_crc.bin
ADV adv-loader		SPL

Running mfgtool and update

running the MfgTool2.exe and update

1. If you can’t running mfgtool2.exe, you can check MfgTool.log
2. Click “Start”,you can get information form debug console

   

3. After update finish,it will be shown below

   

4. Click “Exit” to terminate the application.