Difference between revisions of "MCU/WISE-1530"
From ESS-WIKI
Erick.huang (talk | contribs) |
Erick.huang (talk | contribs) |
||
| Line 228: | Line 228: | ||
== DB1502 == | == DB1502 == | ||
| − | *Source code | + | *[[DemoBosch_v1.0.zip|Source code]] |
== RF Test Manual == | == RF Test Manual == | ||
[[WISE-1530_RF_Continue_Tx_Manual|RF Continue Tx Manual]] | [[WISE-1530_RF_Continue_Tx_Manual|RF Continue Tx Manual]] | ||
Revision as of 08:39, 12 October 2018
WISE-1530
M2.COM Low Power Wi-Fi + BT4.1 IoT Node
- ARM Cortex-M4 processor
- RAM 256 KB memory / 1MB Serial Flash
- Single band 2.4GHz IEEE 802.11b/g/n + BT4.1
- Support
| UART(2 wire) | I2C | SPI | GPIO | ADC | I2S |
| 1 | 1 | 1 | 2 | 4 | 1 |
- 22 x 30 mm M.2 key E
M2.COM Pinout
| 1 | GND | VCC | 2 |
| 3 | N.C. | VCC | 4 |
| 5 | N.C. | N.C. | 6 |
| 7 | GND | I2S_CK_MICRO | 8 |
| 9 | N.C. | I2S_WS_MICRO | 10 |
| 11 | N.C. | I2S_SD_MICRO | 12 |
| 13 | N.C. | N.C. | 14 |
| 15 | N.C. | CB_RESET_OUT# | 16 |
| 17 | N.C. | GND | 18 |
| 19 | N.C. | N.C. | 20 |
| 21 | N.C. | UART TX |
22 |
| 23 | N.C. | Connector Key | |
| Connector Key | Connector Key | ||
| Connector Key | Connector Key | ||
| Connector Key | Connector Key | ||
| Connector Key | UATR RX | 32 | |
| 33 | GND | N.C. |
34 |
| 35 | N.C. | N.C. |
36 |
| 37 | N.C. | GPIO0 | 38 |
| 39 | GND | GPIO1 | 40 |
| 41 | N.C. | CB_PWR_ON | 42 |
| 43 | N.C. | GPIO_3_WL | 44 |
| 45 | GND | GPIO_4_WL |
46 |
| 47 | ADC0 | GPIO_5_WL | 48 |
| 49 | ADC1 | GPIO_6_WL | 50 |
| 51 | GND | N.C. | 52 |
| 53 | ADC2 | N.C. | 54 |
| 55 | ADC3 | N.C. | 56 |
| 57 | GND | I2C0_DATA | 58 |
| 59 | N.C. | I2C0_CLK | 60 |
| 61 | N.C. | SPI_MOSI | 62 |
| 63 | GND | SPI_MISO | 64 |
| 65 | +VBAT_R | SPI_CLK | 66 |
| 67 | N.C. | SPI_CS0# | 68 |
| 69 | GND | N.C. | 70 |
| 71 | RESET_IN# | VCC | 72 |
| 73 | WAKEUP# |
VCC | 74 |
| 75 | GND |