Revision as of 03:00, 7 May 2020

Configuration

The RK3399 bank/bit notation for GPIOs must be formed as "GPIO<GPIO_bank>_<gpio_bit>" 

The numeric value of GPIO is calculated as follows:

32 x (gpio_bank) + gpio_bit

gpio_bit : A0～A7 0-7 B0～B7 8-15 C0～C7 16-23 D0～D7 24-31

E.g. GPIO2_B0 becomes 72

RSB-4710

Test

Export GPIO then you can use control GPIO from userr space through sysfs

Export GPIO1

# echo 72 > /sys/class/gpio/export

Set GPIO direction to in/out

# echo "out" > /sys/class/gpio/gpio72/direction

Set GPIO value 0/1 if GPIO pin define is output

#  echo 1 > /sys/class/gpio/gpio72/value

Used as IRQ signal

Note:You have to configure GPIO to input

#  echo "rising" > /sys/class/gpio/gpio72/edge

• rising: Trigger on rising edge
• falling: Trigger on falling edge
• both: Trigger on both edges
• none: Disable interrupt on both edges

Unexport GPIO1

# echo 72 > /sys/class/gpio/unexport

Test

GPIO1 and GPIO2 are taken as an example:

• Connect GPIO1 and GPIO2
• Export GPIO1 and GPIO2

# echo 72 > /sys/class/gpio/export
# echo 50 > /sys/class/gpio/export

• Set GPIO 1 to output

# echo "out" > /sys/class/gpio/gpio72/direction

• Set GPIO 2 to input

# echo "in" > /sys/class/gpio/gpio50/direction

• Change GPIO1 to 1 and read GPIO2value

# echo 1 > /sys/class/gpio/gpio72/value
# cat /sys/class/gpio/gpio50/value 
1

• Change GPIO1 to 0 and read GPIO2 value

# echo 0 > /sys/class/gpio/gpio72/value
# cat /sys/class/gpio/gpio50/value 
0