Difference between revisions of "1. Using RKTool RSB-4810 Debain"

Revision as of 07:46, 19 October 2023

For example, the PC used is a laptop. The specifications are as follows：

Decompress the downloaded image on the PC.

Step 1 ：Extract Driver Assitant_v5.11.zip and follow these steps: Mounting driver.

Run the installer and wait for the installation to succeed

Step 2 : Go to the RKDevTool_Release folder and run the RKDevTool.exe program

Step 3 : Ensure that the path to the burned file is correct

Step 4 : The device enters the burn mode

a ) A data cable with male USB connectors at both ends is available.

b ) Connect jumper cap J4 to Pin1 - Pin2(set USB-otg mode).

Note：Default jumper cap J4 Connect Pin2-Pin3 (Set USB-host mode)

c ) Connect one part of the USB cable to the USB port below and the other end to the computer.

d ) Jump the J1 jumper cap to Pin1-Pin2, then switch on the 12V power supply.

e ) Then the burning tool will appear: a MASKROM word found.

Note：Suspend or shut down the virtual machine during this process; otherwise, the pop-up information may affect the burning results.

f ) Jump the J1 jumper cap back to Pin2-Pin3 and click "Execute"

g ) Just wait patiently for the burning to finish.