Revision as of 06:39, 19 July 2017

Preparing for Hardware

The user needs to prepare for hardware as following:

• WISE-1530 and WISE-1500 board.
• WISE-1500 power cable.
• WISE-1530 antenna.
• USB-to-UART cable.
• 802.11b/g/n (2.4 GHz) Wireless Access Point (AP).
• PC running the Microsoft® Windows® 7 operating systems

Please refer to the following steps for setup a WISE-1530 boards.

Step01: Please prepare boards as below.

① WISE-1530

② WISE-1500

③ Power connector

④ Reset button

⑤ UART connector

⑥ RF connector    

Step02: Connect the WISE-1530 to PC via USB-to-UART cable.

• Install USB-to-UART driver.
• The device will be visible in the Device Manager as below, user can use serial port tools (putty, tera term ...etc.). 

RF Test Command

Launch serial port tool, you can see " Console app start, type 'help' " on screen after power on or reset.

Join: Connect to AP

    join <ssid> <open|wpa_aes|wpa_tkip|wpa2|wpa2_tkip|wpa2_aes|wep> [key] [channel] [ip netmask gateway]

    Ex: join RT66 wpa2_aes 987135238

Ping:  

    ping <destination> [-i <interval in ms>] [-n <number>] [-l <length>]

    Ex: ping 192.168.1.1 -i 10 -n 10

Iperf: Test continue Tx

   iperf [-s|-c host ip] [options]

   -u: use UDP mode

   -t: time(second)

   Ex: iperf -c 192.168.1.1 -u -t 30