Linux BSP build User Guide (LSDK20.12)
Contents
Linux BSP Version
Ubuntu 18.04
Kernel 5.4.47
Released Image
Download flex-installer
$ wget https://www.nxp.com/lgfiles/sdk/lsdk2012/flex-installer && chmod +x flex-installer && sudo mv flex-installer /usr/bin
Build Environment on Host
If you don't have docker in your system, then you can follow the below steps to install docker and run it first.
Log in to a Docker registry
$ docker login -u advcus -p iTk7Sy9OQVQCkN2FPKw=Om8mfwfZQqKi riscswacr.azurecr.io
Pull Ubuntu 18.04 from Azure Container Registry
$ docker pull riscswacr.azurecr.io/u18.04-ls1046albv1:latest
Run/Create Docker Container
$ docker run -it --name ${CONTAINER_NAME} --privileged -v ${WORK_SPACE}:/home/adv/flexbuild_lsdk2012:rw riscswacr.azurecr.io/u18.04-ls1046albv1 /bin/bash
Get BSP
Download BSP from Azure DevOps
The following example shows how to download the Advantech LSDK flexbuilder from DevOps. (Execute in Docker container)
For this example, a directory called adv-release-bsp is created for the project.
$ cd adv-release-bsp $ git clone https://AIM-Linux@dev.azure.com/AIM-Linux/flexbuild_lsdk2012/_git/flexbuild_lsdk2012
Build Images
These commands are execute in Docker environment.
$ cd flexbuild_lsdk2012 $ source setup.env $ flex-builder -i mkfw -m ls1046ardb -b sd $ flex-builder -i mkrfs -a arm64 $ flex-builder -i mkbootpartition -a arm64
Flash Images (In Local Host)
The following example is for sd card :
$ cd adv-release-bsp/flexbuild_lsdk2012/build/images/ $ flex-installer -i pf -d /dev/sda $ flex-installer -f firmware_ls1046ardb_uboot_sdboot.img -b bootpartition_LS_arm64_lts_5.4_xxxxxxxxxxxx.tgz -r rootfs_lsdk2012_ubuntu_main_arm64.tgz -d /dev/sda
How to Flash eMMC
Boot Mode
QSPI Mode | MMC mode |
|
|
Burn In Boot-Loader to QSPI Flash
You need a bootable SD card (follow above section), and switch to MMC boot mode.
Insert your SD card and follow below flow in U-boot console.
Set FTP Server IP
$ setenv serverip 172.22.31.153
Request IP Address
$ dhcp
Try to Ping FTP Server
$ ping 172.22.31.153
Load U-boot Firmware Image
$ tftp $load_addr firmware_ls1046ardb_uboot_qspiboot.img
Install Image to QSPI (32MB)
$ sf probe 0:0 $ sf erase 0 0x2000000 && sf write $load_addr 0 0x2000000
Shutdown, unplug SD card, switch to QSPI mode and power on the board again.
Boot into U-boot console, then flush the eMMC
$