UIO-4034
From ESS-WIKI
Revision as of 06:29, 1 August 2024 by Jems.cheng (talk | contribs)
[edit]
Note: RS-232: /dev/ttymxc2
RS-485: pin1 data- & pin2 data+ (ttyUSB0)
RS-232
$ stty -F /dev/ttymxc2 -echo -onlcr 115200 crtscts $ cat /dev/ttymxc2 & $ echo "Serial Port Test" > /dev/ttymxc2
CAN Bus
$ ip link set can0 up type can bitrate 125000 $ ifconfig can0 up $ ip link set can1 up type can bitrate 125000 $ ifconfig can1 up $ candump can0 & $ cansend can1 1F334455#1122334455667788
RS-232(COM3):
RS-232 x2 (ttymxc1 & ttymxc3) # stty -F /dev/ttymxc1 -echo -onlcr 115200 # cat /dev/ttymxc1 & # echo "Serial Port Test" > /dev/ttymxc1
RS-232(COM4)
# stty -F /dev/ttymxc3 -echo -onlcr 115200 # cat /dev/ttymxc3 & # echo "Serial Port Test" > /dev/ttymxc3
CAN
# ip link set can0 up type can bitrate 125000 # ifconfig can0 up # ip link set can1 up type can bitrate 125000 # ifconfig can1 up # candump can0 & # cansend can1 1F334455#1122334455667788
Rear IO – RS-232 x2 (ttymxc1 & ttymxc3)
RS-232(4034_COM3):
# stty -F /dev/ttymxc0 -echo -onlcr 115200 # cat /dev/ttymxc0 & # echo "Serial Port Test" > /dev/ttymxc0
RS-232(4034_COM4)
# stty -F /dev/ttymxc3 -echo -onlcr 115200 # cat /dev/ttymxc3 & # echo "Serial Port Test" > /dev/ttymxc3
CAN x1
N/A (RSB-3730 not support CAN Bus)
COM Port
Rear IO – RS-232 x 2
USB x 2
Ethernet x 1
Note:
ttyS0– COM3
ttyS4– COM4
RS-232(COM3):
# stty -F /dev/ttyS0 -echo -onlcr 115200 # cat /dev/ttyS0 & # echo "Serial Port Test" > /dev/ttyS0
RS-232(COM3):
# stty -F /dev/ttyS4 -echo -onlcr 115200 # cat /dev/ttyS4 & # echo "Serial Port Test" > /dev/ttyS4
USB3.0 HUB+USB Keyeboard&Mouse USB3.0 driver data copy compare
CAN
$ ip link set can0 up type can bitrate 125000 $ ifconfig can0 up $ ip link set can1 up type can bitrate 125000 $ ifconfig can1 up $ candump can0 & $ cansend can1 1F334455#1122334455667788