Edge Sense LoRa Module Firmware Upgrade
Contents
Requirements
ST-LINK/V2
The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families.
https://www.st.com/en/development-tools/st-link-v2.html
STM32 ST-Link Utility
STM32 ST-LINK Utility (STSW-LINK004) is a full-featured software interface for programming STM32 microcontrollers.
This utility is available at http://www.st.com/en/development-tools/stsw-link004.html
Module
RYLRxxP
Step1 - Insert cable to LoRa module
Step 2 - Open STM32 ST-LINK Utility and select hex file for RYLRxxP (ex: RYLRxxP_V0.2.9.hex) to program flash.
RYLRxx6
Step1 - Insert cable to LoRa module
Step 2 - Open STM32 ST-LINK Utility and select hex file for RYLRxx6 (ex: RYLRxx6_V0.2.10.hex) to program flash.
RYLRxxE
Step1 - Insert cable to LoRa module
Step 2 - Open STM32 ST-LINK Utility and select hex file for RYLRxxE (ex: RYLRxxE_V0.1.16.hex) to program flash.
RYLRxx2
Step1 - Insert cable to LoRa module
Step 2 - Open STM32 ST-LINK Utility and select hex file for RYLRxx2 (ex: RYLRxx2_V0.2.4.hex) to program flash.
Programming via STM32 ST-Link Utility
Step1 - Connect device
Step2 - Select hex file
Step3 - click "Program verify" button
Step4 - Click "Start"
Reference
- Lora程式更新與燒錄法 V0.93.pdf