WISE-ED22 User Manual

From ESS-WIKI
Jump to: navigation, search

ED22 Functions

There are two interfaces that ED22 board provides. Both are drag-n-drop programming and a serial port. In addition ED22 board firmware can be updated using the drag-n-drop programming interface of the bootloader.

H/W Setup

ED22 Introduction

       ED22 board v1.png 

      1. ED22 board reset button.

      2. Target MCU(STM32L443/STM32F412/STM32F486) reset button.

      3. Micro USB connector.

      4.10pin FFC connector.

Connection with target board

 ED22 to taget.png   

 RTENOTITLE

Install Driver

Download latest driver

ED22 Firmware Update

When you get a new WISE-ED22, you must perform the following steps to updated it's FW. Make WISE-ED22 suitable for your product.

Step1: Connect the WISE-ED22 to PC using micro-USB cable. Please hold down the button SW1 and press the button RST1 once, then release the button SW1 and you will  see the CRP DISABLD

        ED22 FW update 1.png

Step2: Open the "CRP Disabled" drive, and delete the file called "firmware.bin"

        ED22 FW update 2 v1.png

Step3:Copy the WISE-ED22 FW that corresponding to target MCU onto the "CRP DISABLD" drive. 

        ED22-firmware-update-01.png

Step4: Press ED22 board reset to restart, then you can see a disk drive called DAPLink.  

        ED22 FW update 4.png

WISE-ED22 FW binary files (you will see the binary file after uncompressed the *.zip) :

    1. STM32L443: WISE-1510/WISE-1511/WISE-1540

    2. STM32F412: WISE-1530/EPD-132

    3. STM32L486: WISE-1570

Using ED22

Drag-n-drop Programming

To use the ED22, simply connect to your PC with a micro-USB cable, and to the WISE-15XX board using a 10 pin FFC cable. You can drag and drop binary images onto the DAPLink disk drive, which will then be programmed into the target system.If errors are encountered, a file called "fail.txt" will appear with details.

Note that the ED22 has to contain the correct firmware to enable drag and drop programming.

RTENOTITLE

Supported file formats:

  • Raw binary file
  • Intel Hex

Serial Port

The serial port is connected directly to the target MCU allowing for bidirectional communication. It also allows the target to be reset by

sending a break command over the serial port.

Supported baud rates:

  • 9600
  • 115200