Revision as of 10:19, 12 June 2017

ED22 

There are three interfaces that ED22 board provides. These are drag-n-drop programming, a serial port and debugging support. In addition ED22 board firmware can be updated using the drag-n-drop programming interface of the bootloader.

Drag-n-drop Programming

Program the target microcontroller(STM32L443/STM32F412) by copying or saving a file in one of the supported formats to the ED22 drive. Upon completion the drive will re-mount. If a failure occurs then the file FAIL.TXT will appear on the drive containing information about the failure.

Supported file formats:

• Raw binary file
• Intel Hex

H/W 

1: ED22 reset button

Reprogramming SWDAP

When a new SWDAP is plugged in to your machine, it will not contain valid any firmware, and so will appear as a disk drive called "CRP Disabled" as.

To progam the SWDAP, follow these steps:

• Open the drive, and delete the file called "firmware.bin"
• Download the required image from the table above (or built your own using DAPLink project)
• Copy the .bin file onto the "CRP Disabled" drive.
  • On Windows, replace firmware.bin with the above firmware
  • On Linux/Mac, use command: dd if={new_firmware.bin} of={firmware.bin} conv=notrunc
• Unplug your SWDAP, and plug it back in
• It should now appear as a disk drive called DAPLink

You can re-program your SWDAP at any time by plugging it in with the button held down. This will cause it to appear as the "CRP Disabled" drive, at which point you can follow the steps above.