MCU/WISE-1570 SDK

Introduction

This document is description about WISE-1570 software development kit (SDK). It includes source tree of SDK, development environment, flash programming…etc.

WISE-1570 Software Development Kit (SDK)

Preparing for Hardware

The user needs to prepare for hardware as following:

• For mote, WISE-1570, WISE-1500 and WISE-ED20 or WISE-ED22.
• PC running LINUX operating systems such as Ubuntu 16.04.1.

Please refer to the following steps for setup a WISE series of boards before using WISE-1540 SDK.

Step01: Please prepare boards as below.

①WISE-1570
The user must to choose the CN1 on WISE-1570 as below is connected to WISE-ED20 or WISE-ED22 through FPC.

②WISE-1500

③WISE-ED20

④SW2 on WISE-ED20

• Please check pin1 and pin2 to “ON” as default.
• Switch pin1 to “ON”: flash programming, “OFF”: boot from flash.

⑤CN2 on WISE-1500

• Booting into the mode of network connection when both 3.3V and GPIO0 are opened.
• Booting into the mode of console of API when both 3.3V and GPIO0 are shorted.

⑥SW3 on WISE-1500

• Please check pin1 and pin2 to “OFF” as default.
• Switch pin2 to decide whether running “backup to default” while device booting. “ON”: enabled, “OFF”: disabled.

⑦One reset button on WISE-1500 and the other on WISE-ED20

⑧Micro USB connector

• Power supplies for UART3 debug port.

⑨Com port

• No supported.

Step02: Connect the WISE-ED20 to PC using micro-USB cable.

The device will be visible in the Device Manager as below after FTDI driver installed. The user can find the FTDI driver in source tree.

ARM mbed

The ARM mbed is IoT device platform and it has a lot of resources for IoT development. We supported ARM mbed OS on WISE-1540 to make user easily to get started and obtain great benefit from ARM mbed.

mbed CLI

The mbed CLI is command-line tool. The user needs to setup CLI for WISE-1540 SDK. Please refer to below link for information about how to setup CLI.

• mbed CLI

mbed CLI configuration

• GCC_ARM_PATH

Set GCC_ARM_PATH to the binary directory of your GCC Arm installation

$ mbed config -G GCC_ARM_PATH "/home/erick/gcc-arm-none-eabi-4_9-2015q3/bin"
[mbed] /home/erick/gcc-arm-none-eabi-4_9-2015q3/bin now set as global GCC_ARM_PATH

Flash Programming

For flash programming, the user can do it through WISE-ED22 or WISE-ED20 with different programming tool. Please refer to the following steps for flash programming.

Programming through WISE-ED22

Please refer to WISE-ED22 for flash programming.