MCU/WISE-1540 SDK

Introduction

This document is description about WISE-1540 software development kit (SDK). It includes source tree of SDK, development environment, flash programming…etc. There are some examples provided by WISE-1540 SDK the user can refer to it for how to do about connection to WISE-PaaS, communication between mote and gateway…etc., and also can refer to it for developing their application.

Glossary

• Gateway

The gateway like WISE-3310 has connectivity with SmartMesh IP manager responsible for communication with WISE-1540.

• Mote

The mote is WISE-1540 that has connectivity with SmartMesh IP mote responsible for communication with gateway.

WISE-1540 Software Development Kit (SDK)

Source Tree

The user can find source tree as below from xxx.

Directory	Description
doc/	Documents about WISE-1540 SDK.
inc/	Header files including examples, sensor driver and etc.
lib/	Library.
src/	Source files including examples, sensor driver and etc.

Setup Development Environment

Preparing for Hardware

The user needs to prepare for hardware as following:

• For mote, WISE-1540, WISE-1500 and WISE-ED20 or WISE-ED22.
• For gateway, WISE-3310.
• PC running LINUX operating systems such as Ubuntu 16.04.1.

Please refer to the following steps for setup a WISE series of boards before using WISE-1540 SDK.

Step01: Please prepare boards as below.

①WISE-1540

②WISE-1500

③WISE-ED20

④SW2 on WISE-ED20

• Please check pin1 and pin2 to “ON” as default.
• Switch pin1 to “ON”: flash programming, “OFF”: boot from flash.

⑤CN2 on WISE-1500

• Booting into the mode of network connection when both 3.3V and GPIO0 are opened.
• Booting into the mode of console of API when both 3.3V and GPIO0 are shorted.

⑥SW3 on WISE-1500

• Please check pin1 and pin2 to “OFF” as default.
• Switch pin2 to decide whether running “backup to default” while device booting. “ON”: enabled, “OFF”: disabled.

⑦One reset button on WISE-1500 and the other on WISE-ED20

⑧Micro USB connector

• Power supplies for UART3 debug port.

⑨Com port

• No supported.

Setting for Connectivity

WISE-1540 is designed in connectivity for wireless IoT communication with Linear Dust SmartMesh IP wireless sensor networks. The Linear Dust networks support a self-forming and self-healing mesh network solution complaint to 6LoWPAN Internet Protocol (IP) and IEEE802.15.4e standard. Before using WISE-1540 SDK, the user needs to check or set some parameters through the console for API.